Konica Minolta bizhub 750 - Manual (Page 125)

3 Basic Copy Operations
3-26 bizhub 750/600
Ba
sic Copy Op
er
ations
Chapter 3
3.5 Selecting a Paper Setting
The paper size can be selected automatically according to the original size
or it can be specified manually. Specify the paper size according to the cor-
responding procedure, depending on the desired copy settings.
2
Note
If a setting for special paper is selected for a paper tray, that tray is not
selected automatically with the “Auto Paper Select” setting. (However, a
paper tray set to “Single Side Only” is given priority to be selected.) This
setting is useful for paper trays loaded with special paper. For details, re-
fer to “To specify a setting for special paper” on page 7-20.
The default setting is “Auto Paper Select”.
For details on the operations that cannot be combined, refer to “Opera-
tions That Cannot Be Combined” on page 3-5.
The “Auto Zoom” and “Auto Paper Select” settings cannot be selected at
the same time. If the “Auto Zoom” setting is selected, select the desired
paper size in the Paper screen.
Check the screen for the paper that is selected. Touch [Paper] to display
the size and orientation of the selected paper and the amount of paper
remaining. The amount of paper remaining is indicated in five levels. If
special paper is selected, the special paper type is indicated with icons.
For details, refer to “Icons That Appear in the Touch Panel” on page 2-18.
Automatically Selecting the Paper Size (“Auto Paper Select” Setting)
The size of the positioned original is detected, and copies are produced us-
ing paper of the same size.
If the “×1.0” Zoom setting was specified, paper of the same size as the orig-
inal is selected.
If the zoom ratio was increased or decreased, a paper size that corresponds
to the specified zoom ratio is automatically selected.