Konica Minolta bizhub 750 - Manual (Page 72)

Before Making Copies 2
bizhub 750/600 2-27
Before Making C
o
pies
Chapter 2
!
Detail
The following are cleared when the main power switch and sub power
switch are turned off.
Settings that have not been programmed
Jobs queued to be printed
When turning the main power switch off then on, be sure to wait 10 sec-
onds or longer before turning it on again;
otherwise the machine may not operate properly.
Automatically Canceling the Settings (Automatic Panel Reset)
If the [Reset] key is not pressed and no operation is performed for a specified
length of time, settings that have not been programmed, such as the number
of copies, are cleared and return to their default settings.
This is the automatic panel reset operation.
As the factory default, the automatic panel reset operation is performed after
1 minute.
!
Detail
The length of time until the automatic panel reset operation is performed
and whether or not it is performed can be set from the Utility mode. For
details, refer to “System Setting” on page 12-14.
Automatically Canceling the Mode Screen (Automatic System Reset)
If no operation is performed for a specified length of time, the screen is au-
tomatically changed to that for the mode given priority.
This is the automatic system reset operation.
As the factory default, the Copy mode screen is displayed after 1 minute.
!
Detail
The mode screen that is displayed when the automatic system reset op-
eration is performed can be changed from the Utility mode. For details,
refer to “System Setting” on page 12-14.