Konica Minolta bizhub 750 - Manual (Page 186)

Additional Copy Operations 4
bizhub 750/600 4-11
Addition
al Copy Op
era
tions
Chapter 4
? Can the copy program name be corrected?
% To change the entered copy program name, touch the button
whose name is to be changed, and then touch [Edit Name].
4
Use the keyboard that appears in the touch panel to type in the name
of the copy program.
– A name of up to 16 characters can be specified for the registered
copy program. (For details, refer to page 13-2.)
5
After typing in the name, touch [OK].
– The copy program can be given the same name as a copy program
that has already been registered.
The Recall Copy Program screen appears again. The copy program is
registered and a button with the entered copy program name appears.
? Can the specified settings for a copy program be checked?
% To check the programmed copy settings, touch the button for the
desired copy program, and then touch [Check Job]. For details, re-
fer to “Copying With Programmed Copy Settings (Mode Memory)”
on page 4-14.
? How is a job deleted?
% Touch the button for the desired copy program, and then touch
[Del.]. In the screen that appears, requesting confirmation to delete
the copy program, touch [Yes] to delete the selected copy program.