Konica Minolta bizhub 750 - Manual (Page 48)

Before Making Copies 2
bizhub 750/600 2-3
Before Making C
o
pies
Chapter 2
2
Note
The maximum angle that the ADF is opened can be adjusted in two stag-
es. For details, contact your technical representative.
No. Part Name Description
1 ADF (automatic document feeder) Automatically feeds one original sheet at a time for
scanning. If the double-sided original setting is se-
lected in the touch panel, the original is automatical-
ly turned over so that both sides can be scanned.
Referred to as the “ADF” throughout the manual.
2 Toner cartridge door Opened when replacing the toner cartridge (See
p. 9-4.)
3 Working table Provides an area to temporarily place original and
other materials
4 Sub power switch Use to turn on/off machine operations, for example,
for copying, printing or scanning. When turned off,
the machine enters a state where it conserves ener-
gy.
5 Multiple bypass tray Used when printing onto paper with a size not load-
ed into a paper tray or onto overhead projector
transparencies or trace paper
Holds up to 100 sheets of plain paper and 1 sheet
of overhead projector transparencies or trace pa-
per.
Referred to as the “bypass tray” throughout the
manual. (See p. 2-44)
6 Right-side door of the paper tray Opened when clearing paper misfeeds
7 Tray 4 Can be loaded with up to 500 sheets of paper (20lb),
and can be set to different paper sizes (See p. 2-41.)
8 Tray 3 Can be loaded with up to 500 sheets of paper (20lb),
and can be set to different paper sizes (See p. 2-41.)
9 Tray 2 Can be loaded with up to 1,000 sheets of paper
(20lb) (See p. 2-39.)
10 Tray 1 Can be loaded with up to 1,500 sheets of paper
(20lb) (See p. 2-39.)
11 Touch panel Displays various screens and messages.
12 Control panel Used to specify the various machine settings (See
p. 2-14.)
13 Front doors (left and right) Opened when clearing paper misfeeds
14 Exit tray Collects printed pages