Konica Minolta bizhub 750 - Manual (Page 482)

Utility 12
bizhub 750/600 12-69
Utility
Ch
ap
te
r 12
5
Touch [6 2 Position Staple].
The 2 Position Staple screen appears.
6
Touch the button for setting to be specified.
7
Touch [Test Copy].
The Test Copy screen appears.
8
Press the [Start] key.
The sample copy is printed.
9
Touch [Close].
The 2 Position Staple screen appears again.
10
Check the stapling positions in the sample copy.
11
If the desire print results are not achieved, change the adjustment val-
ue.
– Touch [+] and [–] to adjust the distance (between 128 and 160 mm)
between the staples.
12
Repeat steps 6 through 11 until the desired print results are achieved.
13
Touch [OK].
– To cancel changes to the settings, touch [Cancel].
2
Note
Enter the value by mm using the keypad. Refer to the conversion rate be-
low. 1 in. = 25.4 mm