Konica Minolta bizhub 750 - Manual (Page 265)

7 Copy Paper/Original
7-28 bizhub 750/600
Copy Paper/Original
Chapter 7
3
Touch [Custom Size].
– The Paper Size screen that appears differs depending on the paper
size type that is selected.
4
Type in the length (X) and width (Y) of the paper.
– Touch [
↔] to switch between the integer and the fraction, and then
touch [–] and [+] to type in the length of side X. (5-1/2 in. to 18 in.)
– Touch [
↔] to switch between the integer and the fraction, and then
touch [–] and [+] to type in the length of side Y. (7-3/16 in. to 12-3/
8 in.)
– If a decimal value is displayed in the screen, use the keypad to type
in the length. For details on switching between decimal and fraction
values, refer to “System Setting” on page 12-14.
– If a decimal value is displayed in the screen and the specified value
is outside the allowable range, the message “Input Error” appears.
Type a value within the allowable range. If the value was incorrectly
entered, press the [C] (clear) key to erase the value, and then spec-
ify the correct value.
5
Touch [OK].