Konica Minolta bizhub 750 - Manual (Page 252)

Copy Paper/Original 7
bizhub 750/600 7-15
Copy Paper/Original
Chapter 7
4
Specify the X and Y sides of the paper, and then touch [Store].
– Touch [X], touch [
↔] to switch between the integer and the fraction
and then touch [–] and [+] to type in the length of side X. (5-1/2 in.
to 18 in.)
– Touch [Y], touch [
↔] to switch between the integer and the fraction
and then touch [–] and [+] to type in the length of side Y. (3-15/16
in. to 12-5/16 in.)
– Check the illustration in the screen for the sides that are considered
as X and Y.
– If a decimal value is displayed in the screen, use the keypad to type
in the length. For details on switching between decimal and fraction
values, refer to “System Setting” on page 12-14.
– If a decimal value is displayed in the screen and the specified value
is outside the allowable range, the message “Input Error” appears.
Type a value within the allowable range. If the value was incorrectly
entered, press the [C] (clear) key to erase the value, and then spec-
ify the correct value.
5
Touch [memory1] or [memory2].
? How can the name of the stored paper size be changed?
% Touch [Custom Name], then type the new name into the Custom
Name screen that appeared, and then touch [OK].
% Use the keyboard that appeared in the screen to type in the new
name, and then touch [OK].