Konica Minolta bizhub 750 - Manual (Page 332)

Application Functions 8
bizhub 750/600 8-59
Application F
unctions
Chapter 8
– To specify no shift either horizontally or vertically, touch [No Shift].
Specify the horizontal (left and right shift) or vertical (up and down shift)
shift.
6
Touch [Edit 2nd Side].
The Edit 2nd Side screen appears.
7
Specify the shift direction and amount.
– For a horizontal shift, touch [Left] or [Right] to specify the shift di-
rection.For a vertical shift, touch [Top] or [Bottom] to specify the
shift direction. Both a horizontal shift and a vertical shift can be
specified together.
– To specify no shift either horizontally or vertically, touch [No Shift].
– Touch [
↔] to switch between the integer and the fraction, touch
[–] and [+] to specify the width to be erased, and then touch [OK].
– If a decimal value is displayed in the screen, use the keypad to type
in the setting. For details on switching between decimal and frac-
tion values, refer to “System Setting” on page 12-14.
– When using the keypad to specify the settings, press the [C] (clear)
key, and then type in the setting. If a value outside the allowable
range is specified, the message “Input Error” appears. If “Input Er-
ror” appeared or if the distance was incorrectly entered, press the
[C] (clear) key to erase the value, and then specify the correct value.