Konica Minolta bizhub 750 - Manual (Page 182)

Additional Copy Operations 4
bizhub 750/600 4-7
Addition
al Copy Op
era
tions
Chapter 4
7
Press the [Proof Copy] key to print another sample copy.
– If copying stops while the proof copy screen or the Change Setting
screen is displayed after the proof copy was printed, press the [Re-
set] key.
Otherwise, from the list of jobs on the left side of the touch panel,
select the proof copy job that stopped, and then touch [Delete]. In
the screen that appears, requesting confirmation to delete the copy
program, touch [Yes].
– Whether an image or list appears in the sub display area can be se-
lected by using the “Sub Screen Display ON/OFF” parameter in
Utility mode. (For details, refer to page 12-19.)
– If an automatic panel reset operation is performed while the proof
copy for a job is being checked, that job is stored in the memory.
– To stop the proof copy while scanning or printing, perform the op-
eration described in “Stopping Scanning/Printing” on page 3-74.
– If multiple copies have been specified, another sample copy can be
printed.
8
Touch [Print].
– The remaining copies begin to be printed.