Konica Minolta bizhub 750 - Manual (Page 347)

8 Application Functions
8-74 bizhub 750/600
Application F
unctions
Chapter 8
4
Touch [Center Erase].
The Center Erase screen appears.
5
Touch [–] and [+] or use the keypad to specify the width to be erased.
– Touch [
↔] to switch between the integer and the fraction, touch[–]
and [+] to specify the width to be erased, and then touch [OK].
– If a decimal value is displayed in the screen, use the keypad to type
in the setting. For details on switching between decimal and frac-
tion values, refer to “System Setting” on page 12-14.
– When using the keypad to specify the settings, press the [C] (clear)
key, and then type in the setting.
– If a value outside the allowable range is specified, the message “In-
put Error” appears. If “Input Error” appeared or if the distance was
incorrectly entered, press the [C] (clear) key to erase the value, and
then specify the correct value.
– To cancel the “Center Erase” function, touch [OFF].
– To cancel changes to the settings, touch [Cancel].
6
Touch [OK] twice.
7
If necessary, specify any other copy settings.
8
Using the keypad, type in the desired number of copies.