Konica Minolta bizhub 750 - Manual (Page 473)

12 Utility
12-60 bizhub 750/600
Utility
Ch
ap
te
r 12
– If the punch positions are too far on the left side of the paper, touch
[–] (between –0.1 mm and –5.0 mm).
12
Repeat steps 7 through 11 until the desired print results are achieved.
13
Touch [OK].
– To cancel changes to the settings, touch [Cancel].
2
Note
Enter the value by mm using the keypad. Refer to the conversion rate be-
low. 1 in. = 25.4 mm
When PK-505 and ZU-602 are installed, adjustments can be made using
both the “Punch Adjustment” and “Z-Fold Position Adjustment” param-
eters. Contact your technical representative.