Yokogawa ADMAG AXF - Manual (Page 21)

IM 1E10C1-E 5-2
5. FUNCTION AND DATA SETTINGS
5.1 Setting Nominal Size
Switch Operation Display Description
SET SHIFT INC
SET SHIFT INC
SET SHIFT INC
SET SHIFT INC
SET SHIFT INC
SET SHIFT INC
SET SHIFT INC
SET SHIFT INC
SET SHIFT INC
SET SHIFT INC
SET SHIFT INC
SET SHIFT INC
SET SHIFT INC
SET SHIFT INC
SET SHIFT INC
Change the display into the setting mode through the password
input mode. (Please refer to Chapter 4 “BASIC OPERATION
PROCEDURES.”)
By touching the SHIFT and INC key, select the parameter No.
“b06”.
By touching the SET key, change the display into the data
changing mode.
By touching the INC key, select code
“01” for inch.
By touching the SET key, whole Display is blinking.
And by touching the SET key again, the data is completed.
By touching the SET key again, the display goes back to the
number changing mode.
By touching the SHIFT and INC key, select the parameter No.
“b07”.
By touching the SET key, change the display into the data
changing mode.
By touching the SHIFT key, the cursor moves to the next digit.
By touching the INC key, change “1” into “0”.
By touching the SHIFT key, the cursor moves to the next digit.
By touching the INC key, change “0” into “2”.
By touching the SET key twice, the setting is completed.
By touching the SET key again, the display goes back to the
number changing mode.
Defalt is set as 00 (Size Unit is mm). Below is an example to set it “01” .(Size Unit is inch)
Below is an example to change to “2.0”.
(Setting is now completed)
(Setting is now completed)
(See 4.2.1 The initial
procedure to change the
display)
SET SHIFT INC
Size Unit
mm
inch
Code
00
01