Yokogawa ADMAG AXF - Manual (Page 58)

IM 1E10C1-E
7-8
7. OPERATION VIA HART COMMUNICATOR
7.3 Parameters
7.3.1 Parameters Configuration
Parameters of HART Communicator is constructed hierarchically. The menu tree for
Online menu is shown in 7.3.3 Menu Tree.
See “Chapter 11. Parameter List” about the usage of each parameter. Note the differ-
ences between parameters on ADMAG SE display and those on HART Communicator.
The Online menu summary is shown below.
Table 7.1.3Online Menu Summary
No. Display Item Contents
1
2
3
4
Device setup
PV
PV AO
SPAN
Set parameters for ADMAG SE.
Display process value in engineering unit.
Display analog output in mA.
Display set span in engineering unit.
7.3.2 Data Renewing
There are two methods to load the data of ADMAG SE from/to HART Communicator,
periodic data renewing and discretionary data renewing.
(1) Periodic Data Renewing
The follwing data are renewed in 0.5 to 2 seconds cycle.
PV, PV AO, PV % rnge, Totl, Reverse total, Diff. total, Power freq, Velocity
check
(2) Discretionary Data Renewing
The following data can be loaded from/to ADMAG SE. Up load can be done with
SAVE (F2) on any online menu, and down load can be done on Saved Configuration
menu in Offline menu. (Refer to HART Communicator Manual.)
Descriptor, Message, Date, Tag, Span, Line size, Size unit, PV Damp, Base vol
unit, Base time unit, Disp select, Fl user sel, Fl user span, Total unit, Total scale,
Total low cut, Tl set value, Total set, Analog low cut, Analog low lmt, Analog hi
lmt, Analog alarm out, Output function, Pulse unit, Pulse scale, Pulse low cut,
Pulse width.
The changed data with HART Communicator is sent to ADMAG SE by pressing
SEND (F2) of HART Communicator.
NOTE