1 – create a micro800 project, Create a micro800 project, Introduction – Rockwell Automation 2080-LC50 Getting Started with Motion Control Using a Simulated Axis User Manual
Page 11: Before you begin, What you need, Chapter 1, Introduction before you begin what you need
Advertising
1
Publication 2080-QS001A-EN-E - January 2013
1
Chapter
1
Create a Micro800 Project
Introduction
In this chapter, you will create a sample Micro830/Micro850 controller project through the Connected Components
Workbench.
Before You Begin
Ensure that you have Connected Components Workbench revision 2 properly installed.
What You Need
• Connected Components Workbench revision 2 or later
• Firmware revision 2 and later for Micro830 controllers
Advertising
This manual is related to the following products: