Rockwell Automation 2080-LC50 Getting Started with Motion Control Using a Simulated Axis - Manual (Page 15)

5 Publication 2080-QS001A-EN-E - January 2013 5
Chapter
2
Configure Motion Axis Properties
Introduction
In this chapter, you will configure the axis parameters through Connected Components Workbench.
Before You Begin
Acquire a basic understanding of the different motion axis parameters by referring to the Micro830 and Micro850
Programmable Controllers User Manual, publication
2080-UM002 and/or the Connected Components Workbench
Online Help.
What You Need
• Connected Components Workbench revision 2 or later
• Firmware revision 2 and later for Micro830 controllers
Topic Page
Configure General Properties 7
Configure Motor and Load Properties 9
Configure Limits Properties 10
Configure Dynamics Properties 11
Configure Homing Properties 12