Rockwell Automation 2080-LC50 Getting Started with Motion Control Using a Simulated Axis - Manual (Page 34)

24 Publication 2080-QS001A-EN-E - January 2013
Chapter 3 Write Your Motion Control Programs
12. Create a fourth rung. From the
Toolbox, select rung and drag it
onto the space just below the
third rung.
13. Select Branch from the Toolbox
and drag it onto the fourth rung.
14. Select Pulse Rising Edge Direct
Contact from the Toolbox and
drag it onto the fourth rung as
shown.
15. Select Block from the Toolbox
and drag it onto the branch on
fourth rung as shown.