Rockwell Automation 2080-LC50 Getting Started with Motion Control Using a Simulated Axis - Manual (Page 18)

8 Publication 2080-QS001A-EN-E - January 2013
Chapter 2 Configure Motion Axis Properties
5. Click General to bring up the
General properties tab.
6. Configure the general properties
as shown in the table.
General Properties Parameters
Parameter Value
Axis Name Simulator
PTO Channel EM_0
Enable Drive Enable Output Tick option box to enable
Drive Enable Output IO_EM_DO_06
Drive Enable Output Active Level High
Enable Touch Probe Input Tick option box to enable
Touch Probe Input IO_EM_DI_03
Touch Probe Input Active Level High