Rockwell Automation 2080-LC50 Getting Started with Motion Control Using a Simulated Axis - Manual (Page 21)

Publication 2080-QS001A-EN-E - January 2013 11
Configure Motion Axis Properties Chapter 2
Configure Dynamics Properties
1. Under Motion, click Dynamics
to bring up the Dynamics
properties tab.
2. Configure Dynamics parameters
as shown in the table.
Dynamics Properties
Parameter Value
Start/Stop Velocity 20.0 mm/sec
120.0 rpm
Max Velocity 100.0 mm/sec
600.0 rpm
Max Acceleration 1000 mm/sec 2
Max Deceleration 1000 mm/sec 2
Max Jerk 10000 mm/sec 3