ADLINK PCI-8164 - Manual (Page 167)

Motion Creator 155
5.3.3 Pulse I/O and Interrupt Configuration Menu
This menu configures the pulse input/output and move ratio and
INT factor.
1. Pulse Output Mode: Selects the output mode of the
pulse signal (OUT/ DIR). The related function call is
_8164_set_pls_outmode().
2. Pulse Input: Sets the configurations of the Pulse input
signal(EA/EB). The related function calls are
_8164_set_pls_iptmode(),
_8164_set_feedback_src().
3. INT Factor: Selects factors to initiate the event int. The
related function call is _8164_set_int_factor().
4. Buttons:
Z Next Axis: Changes the operating axis.
Z Save Config: Saves the current configuration to
8164.ini.
Z
Operate: Go to the operation menu. Refer to section 5.3.
Z
Config Pulse & INT: Go to the Pulse I/O and Interrupt
Configuration menu. Refer to section 5.3.
Z Back: Return to the main menu.