ADLINK PCI-8164 - Manual (Page 53)

Signal Connections 41
By default, the OUT and DIR are set to differential line driver
mode.
The wiring diagram below illustrates the OUT and DIR signals on
the 4 axes of PCI-8164 card.
NOTE When the pulse output is set to open collector output
mode, OUT- and DIR- transmits OUT signals. The sink
current must not exceed 20 mA on the OUT- and DIR-
pins. By default, pin 1-2 of the jumper is shorted.
USAGE Short pin 2-3 of the jumper and connect OUT+/DIR+ to a
470 ohm pulse input interface’s COM of driver. See the
following figure.
Output Signal
For differential line driver
output, close breaks
between 1 and 2 of:
For open collector out-
put, close breaks
between 2 and 3 of:
OUT1- J1 J1
DIR1- J2 J2
OUT2- J3 J3
DIR2- J4 J4
OUT3- J5 J5
DIR3- J6 J6
OUT4- J7 J7
DIR4- J8 J8