ADLINK PCI-8164 - Manual (Page 294)

282 Connection Example
servo drivers. The signals at CNIF# and SJ# are con-
nected together. DO NOT use them simultaneously.
2. A 50-pin cable is required to connect the Panasonic
MINAS A-series servo driver with the CNIF# connector
on the DIN-814PA. Contact your local ADLINK represen-
tative for additional information.
3. Signals PSD# and MSD# at the connector IOIF# are
assigned different names on the 8164-series motion
control board. The PSD1, PSD2, PSD3, and PSD4 sig-
nals are renamed CMP1, CMP2, LTC3, and LTC4,
respectively. MSD# is replaced by SD/PCS#.