ADLINK PCI-8164 - Manual (Page 277)

Connection Example 265
7 Connection Example
This chapter illustrates connection examples between the PCI-/
MPC-/PXI-8164 card and servo drivers or stepping drivers.
7.1 General Wiring Description
CN1: Receives +24V power from the external power supply. (PCI-
8164 only)
CN2: Main connection between the PCI-8164 and the pulse input
servo driver or stepping driver.
CN3: Receives pulse commands from manual pulse in the PCI-
8164 card.
General Purpose DIO for MPC-8164
CN4: Connector for simultaneously start or stop of multiple PCI-
8164 cards.
CN5: TTL digital output for PCI-8164This example will illustrate
the connection between a Panasonic Servo Driver and the
8164. Figure 9 shows the wiring diagram.
NOTES:
1. For convenience, the drawing shows connections for
single axis only.
2. Default pulse output mode is OUT/DIR. Default input
mode is 1X AB phase. Other modes can be set using the
available software functions.
3. Most general purpose servomotor drivers can operate in
Torque Mode, Velocity Mode, or Position Mode. To con-
nect the card, you must set the operating mode to Posi-
tion Mode.