Labconco Type C1 Biosafety Cabinet Models 30468 - Manual (Page 104)

Product Service 1-800-522-7658 104
Figure 6-13
ECM Power Connector Release Tabs
ECM Data Connector Release Tab
6.
Use a Phillips screwdriver to remove the two sealing plate screws and the sealing
plate. Using a 1/2-inch wrench, remove the three blower mounting bolts, as
shown in Figure 6-14.
Figure 6-14
Blower Mounting Bolts (3)
Sealing plate screws (2)
The motor/blower assembly is heavy. Handle with care.
7. While supporting the blower assembly, pull the assembly straight out the
plenum, as shown in Figure 6-15.
Figure 6-15