Labconco Type C1 Biosafety Cabinet Models 30468 - Manual (Page 5)

Product Service 1-800-522-7658 5
Section Five – Certification Procedures for the Axiom
Accessing the Certifier’s Menu 73
Adjusting the Inflow, Downflow and Filter Life Gauges 73-74
Axiom Filter Life Gauge Operation and Resetting for Local Conditions 75
HEPA Filter Leak Test Information
Supply HEPA Filter Leak Test 76
If the Axiom is contaminated 77
Supply HEPA Filter Leak Test Specifications 77
If the Axiom is uncontaminated 77-79
Exhaust HEPA Filter Leak Test 80-81
Exhaust HEPA Filter Leak Test Specifications 80
Downflow Velocities 81-82
Downflow Test Specifications 81
Inflow Velocity Calculation
Primary Inflow Method 83
Secondary Inflow Method 84-87
Concurrent Balance Values 88
Work Area Air Cleanliness Test (optional) 89
Fluorescent Light Level (optional) 90
Noise Level (optional) 90
Vibration (optional) 91
UV intensity (optional) 91
Ground Fault Circuit Interrupter 92
Section Six – Axiom Service Operations
Recommended Tools for Service 93
External Dress Components
Front Dress Panel Removal and Installation 94
Side Panel Removal 95
Side Panel Installation 95
Corner Post Lower Trim 95-96
Sash Operation/Adjustment 97
Sash Position Switches
Sash Closure Position Switch 98
Sash Restricted Opening Switch 98
8” and 10” Sash Operating Position Switches 99
Sash Cable Retainer 100
HEPA Filter Replacement 100-03
Supply Motor/Blower Replacement 103-05
Exhaust Motor/Blower Replacement 105-06
Center Work Surface Removal 107
Wing Work Surfaces Removal 107-08
Grille Removal 109
Diffuser Removal 110-11
Preparing the Logic for Gaseous Sterilization 112
Section Seven –Electrical System Service Operations
Fluorescent Lamp
Lamp Identification 113
Changing the Fluorescent Lamp 113
Lamp Socket Replacement 114
Optional Ultraviolet Lamp