HEIDENHAIN TNC 335 Technical Manual - Manual (Page 231)

4-134
TNC 360 6 Display and Operation 8/95
6.10 Programming station
Machine parameters can be used to set the control so that it can be utilized without a machine tool
as a programming station, without the machine. In this setting only the operating modes
"Programming and editing" and "Test run" function. It is possible to select whether the PLC should be
active or not in the "programming station" setting.
MP7210 Programming station
Input values: 0 to 2
Entry: 0 = Control and programming
1 = Programming station, "PLC active"
2 = Programming station, "PLC inactive"
6.11 Dialog language
The HEIDENHAIN contouring controls are available in ten different dialog languages, see chapter
"Introduction." The dialog language can be altered by a simple software exchange. English, as a
basic language, is stored in every control as a second language and can be selected by machine
parameter.
If the basic language English has been selected, then marker M2041 is set by the NC.
MP7230 Switching the dialog language
Entry: 0 or 1
0 = First dialog language
1 = Basic language - English
Marker Function Set Reset
M 2041 Basic language - English is selected NC NC
6.12 Decimal sign
The decimal sign can be selected by machine parameter.
MP7280 Decimal sign
Entry: 0 or 1
0 = Decimal comma
1 = Decimal point