HEIDENHAIN TNC 335 Technical Manual - Manual (Page 358)

5-14
TNC 360 3 List of Machine Parameters 4/96
Machine
parameter Function and input Reaction /
CN 123 Page
MP4230.0
to
MP4230.31
to
MP4239.0
to
MP4239.31
Set a number in the PLC via module 9032
Input value: -30 000 000 to + 30 000 000 7-17
MP4310.0
to
MP4310.6 Set a number in the PLC, in the Word range W976
to W988
Input range: 0 to 65 535 7-17
3.7 Setting the data interfaces
Machine
parameter Function and input Reaction /
CN 123 Page
MP5010.0 Control characters for "blockwise transfer"
Input range: 0 to 32 382
Character for program end and beginning
The character for program end also applies for
"Standard data interface" CN 123 8-26
MP5010.1 ASCII characters for data input CN 123 8-27
MP5010.2 ASCII characters for data output CN 123 8-27
MP5010.3 ASCII characters for beginning and end of the
command block CN 123 8-26
MP5010.4 ASCII characters for positive acknowledgment or
negative acknowledgment CN 123 8-26
MP5010.5 ASCII character for data transmission ended CN 123 8-26