HEIDENHAIN TNC 335 Technical Manual - Manual (Page 360)

5-16
TNC 360 3 List of Machine Parameters 4/96
3.8 Measuring with a 3D touch probe
Machine
parameter Function and input Reaction /
CN 123 Page
MP6010 Selection of the touch probe system
Input: 0 or 1
0 = TS 120
1 = TS 511
CN 123 4-152
MP6120 Probing feed rate
Input range: 80 to 30 000 [mm/min] CN 123 4-152
MP6130 Maximum measuring range
Input range: 0.001 to 99 999.999 [mm] CN 123 4-152
MP6140 Safety clearance above measuring point
Input range: 0.001 to 99 999.999 [mm] CN 123 4-152
MP6150 Rapid traverse for probe cycle
Input range: 80 to 30 000 [mm/min] CN 123 4-152
3.9 Digitizing with TS 120 (only with digitizing option)
Machine
parameter Function and input Reaction /
CN 123 Page
MP6210 Number of oscillations per second in normal
direction
Input range: 0 to 65.535 [1/s] 4-156
MP6230 Feed rate in normal direction
Input range: 0 to 10 000 [mm/min] 4-156
MP6240 Maximum deflection of stylus
Input range: 0 to 10.000 [mm] 4-156
MP6250 Numerical value for M function for transferring
modal values
Input 0 to 89
0 = no transfer
1 ... 89 number of the M function 4-157
MP6260 Output of M90 for NC blocks with digitized data
Input: 0 or 1
0 = no output of M90
1 = output of M90 in every NC block 4-157
MP6270 Rounding of trailing zeros
Input: 0 to 1
0 = Output in 0.001 mm increments (1
µ
m)
1 = Output in 0.01 mm increments (10
µ
m)
4-157