HEIDENHAIN TNC 335 Technical Manual - Manual (Page 381)

7-2
TNC 360 8/95
3.1.10 ASSIGN DOUBLEWORD D= 7-36
3.2 Set-commands 7-39
3.2.1 SET S 7-39
3.2.2 RESET R 7-40
3.2.3 SET NOT SN 7-41
3.2.4 RESET NOT RN 7-42
3.3 Logic Gates 7-44
3.3.1 AND A 7-44
3.3.2 AND NOT AN 7-46
3.3.3 OR O 7-48
3.3.4 OR NOT ON 7-50
3.3.5 EXCLUSIVE OR XO 7-52
3.3.6 EXCLUSIVE OR NOT XON 7-54
3.4 Arithmetic Commands 7-57
3.4.1 ADDITION + 7-57
3.4.2 SUBTRACTION – 7-58
3.4.3 MULTIPLICATION x 7-59
3.4.4 DIVISION / 7-60
3.4.5 REMAINDER MOD 7-61
3.5 Comparisons 7-63
3.5.1 EQUAL TO == 7-63
3.5.2 LESS THAN < 7-64
3.5.3 GREATER THAN > 7-65
3.5.4 LESS THAN OR EQUAL TO <= 7-66
3.5.5 GREATER THAN OR EQUAL TO >= 7-67
3.5.6 UNEQUAL <> 7-68
3.6 Parentheses with logical gating 7-70
3.6.1 AND [ ] A[ ] 7-70
3.6.2 AND NOT [ ] AN[ ] 7-70
3.6.3 OR [ ] O[ ] 7-70
3.6.4 OR NOT [ ] ON[ ] 7-70
3.6.5 EXCLUSIVE OR [ ] XO[ ] 7-71
3.6.6 EXCLUSIVE OR NOT [ ] XON[ ] 7-71
3.7 Parentheses with arithmetic commands 7-74
3.7.1 ADDITION [ ] + [ ] 7-74
3.7.2 SUBTRACTION [ ] – [ ] 7-74
3.7.3 MULTIPLICATION [ ] x [ ] 7-74
3.7.4 DIVISION [ ] / [ ] 7-74
3.7.5 REMAINDER [ ] MOD [ ] 7-75
3.8 Parentheses with comparison commands 7-78
3.8.1 EQUAL TO [ ] == [ ] 7-78
3.8.2 LESS THAN [ ] < [ ] 7-78
3.8.3 GREATER THAN [ ] > [ ] 7-78
3.8.4 LESS THAN OR EQUAL TO [ ] <= [ ] 7-78