HEIDENHAIN TNC 335 Technical Manual - Manual (Page 352)

5-8
TNC 360 3 List of Machine Parameters 4/96
Machine
parameter Function and input Reaction /
CN 123 Page
MP920.0
to
MP920.3 Neg. software limit switch for traverse range 1:
Input range:
–99 999.999 to +99 999.999 [mm] or [°] 4-15
MP921.0
to
MP921.3 Neg. software limit switch for traverse range 2:
Input range:
–99 999.999 to +99 999.999 [mm] or [°] 4-15
MP922.0
to
MP922.3 Neg. software limit switch for traverse range 3:
Input range:
–99 999.999 to +99 999.999 [mm] or [°] 4-16
MP950.0
to
MP950.3 Datum point for positioning blocks with M92
Input range:
–99 999.999 to +99 999.999 [mm] or [°]
Values referenced to machine datum 4-110
3.2 Positioning
Machine
parameter Function and input Reaction /
CN 123 Page
MP1010.0
to
MP1010.3 Rapid traverse
Input range: 80 to 300 000 [mm/min] 4-56
MP1020.0
to
MP1020.3 Manual feed
Input range: 80 to 300 000 [mm/min] 4-56
MP1030.0
to
MP1030.3 Positioning window
Input range: 0.001 to 2 [mm] or [°] 4-72
MP1040 Polarity of the nominal value voltage for the
positive direction of traverse
Input range: 0 to 15
Bit 0 X axis +0 = positive
+1 = negative
Bit 1 Y axis +0 = positive
+2 = negative
Bit 2 Z axis +0 = positive
+4 = negative
Bit 3 4th axis +0 = positive
+8 = negative
4-7
MP1050.0
to
MP1050.3 Analog voltage for rapid traverse
Input range: 4.5 to 9 [V] 4-56
MP1060.0
to
MP1060.3 Acceleration
Input range: 0.001 to 3.0 [m/s
2 ]
4-54
MP1070 Radial acceleration
Input range: 0.001 to 3.0 [m/s
2 ]
4-66
MP1080.0
to
MP1080.3 Integral factor
Input range: 0 to 65 535 4-64