HEIDENHAIN TNC 335 Technical Manual - Manual (Page 7)

1-4
TNC 360 Update Information No. 8 4/96
NC status information type: PLC status value:
0: Handwheel interpolation factor for X-axis 0 ... 10
1: Handwheel interpolation factor for Y-axis 0 ... 10
2: Handwheel interpolation factor for Z-axis 0 ... 10
3: Handwheel interpolation factor for 4th axis 0 ... 10
4: Handwheel interpolation factor for all axes 0 ... 10
5: Handwheel interpolation factor for all axes 0 ... 10
6: Select handwheel axis; X-axis 0
Y-axis 1
Z-axis 2
4th axis 3
7 to 9 reserved
10: Limit on jog increment 0 ... 50000 µm
-1 =
Remove limit, activate last jog
increment
-2 = Remove limit, activate minimum from
PLC limit on jog increment and jog
increment input via NC