HEIDENHAIN TNC 335 Technical Manual - Manual (Page 403)

7-24
TNC 360 2 Program Creation 8/95
2.7 Error messages
Error messages aid the programmer in creating the instruction list and testing of the program.
2.7.1 Syntax errors within a command line
These errors may occur when editing a line or on reading it in via the interface.
0 No valid command.
1 Operand for jump is not a Label. (Can only happen when reading in via the interface.
For a Jump command a type abbreviation is available for the Operand).
2 Invalid Operand type (the command cannot be combined with this Operand).
4 Operand outside the permissible range (the stated number is too high, or odd address for
Word or Doubleword).
5 No Limiter after command. (Can only happen when reading in via the interface. The comment
after the command was not designated by ";" or "*").
6 Line end not found (Can only happen when reading in via the interface. Comment too long).
2.7.2 Syntax errors in the course of a program
These errors are recognized during the compilation process. The Editor points to the line where the
error was found. If the PLC program is compiled on switching-on (for example, because the control
was switched off immediately after editing the PLC program) then a flashing message "ERROR IN
PLC PROGRAM" will be displayed. Remedy: switch off and on again, and call the PLC Editor with
the code number. The Editor indicates the position of the error.
7 Called Label has not been defined.
8 No End program condition found (the program does not contain an EM instruction, or it
contains a JP instruction without a following LBL instruction).
9 Program is too long (RAM overflow) (insufficient memory for the program code which is to be
generated).
10 Assign within parentheses (an =, S, SN, R, RN, or PS instruction or a Jump command has
been programmed, although arithmetic parentheses are open).
11 Excessive nesting of parentheses (more than 16 parentheses successively opened).
12 Jump within a gating sequence (an unconditional jump has been programmed, although the
gating sequence was not closed with an Assign ).
13 "Close parentheses" without "open parentheses" (a "close parentheses" command was
programmed, although no parentheses were open).
14 Label within parentheses (a LBL instruction has been programmed, although parentheses are
open).
15 Label within a gating sequence (a LBL instruction has been programmed, although the
previous gating was not closed with an Assign).
16 Jump within parentheses (a jump instruction has been programmed, although parentheses
are open).
17 Parentheses open at end of block (an EM instruction has been programmed, although
parentheses are open).
18 Label defined twice.
19 Word Assign missing (a Logic instruction has been programmed, although the previous Word
gating was not closed with an Assign).