HEIDENHAIN TNC 335 Technical Manual - Manual (Page 364)

5-20
TNC 360 3 List of Machine Parameters 4/96
MP7290 Position-display step
Input: 1 to 4
0 = 0.001 mm or 0.001°
1 = 0.005 mm or 0.005°
2 = 0.010 mm or 0.01°
3 = 0.050 mm 0r 0.05°
4 = 0.100 mm or 0.1°
4-113
MP7300 Cancel status display, Q parameters, and tool data
Input: 0 to 7
0 = Status display, Q parameters and tool data
canceled through program selection
1 = Status display, Q parameters and tool data
canceled through M02, M30, END PGM and
program selection
2 = Status display and tool data canceled through
program selection
3 = Status display and tool data canceled through
M02, M30, END PGM and program selection
4 = Status display and Q parameters canceled
through program selection
5 = Status display and Q parameters canceled
through M02, M30, END PGM and program
selection
6 = Status display canceled through program
selection
7 = Status display canceled through M02, M30,
END PGM and program selection
CN 123 4-119
MP7310 Graphics display
Input range: 0 to 3
Bit 0 Changeover of 3-plane display
+ 0 = European preferred
+ 1 = American preferred
Bit 1 Rotation of the coordinate system in the
machining plane + 90°
+ 0 = no rotation
+ 2 = coordinate system rotated by +90°
CN 123 4-112
MP7330.0
to
MP7330.15 Determination of the User Parameters
Input range: 0 to 9999.00 (Number of the desired
machine parameter) 4-133
MP7340.0
to
MP7340.15 Dialogues for User Parameters
Input range: 0 to 199
0 to 99 from PLC error messages
100 to 199 from dialogue texts 4-133