HEIDENHAIN TNC 335 Technical Manual - Manual (Page 264)

8/95
TNC 360 10 Electronic Handwheel 4-167
3 2.5 1 500
4 1.25 750
5 0.625 80
6 0.312 80
7 0.156 80
8 0.078 80
9 0.039 80
10 0.019 80
Machine parameter MP7670 can be used to select a higher limit than that calculated by the NC.
MP7640 Handwheel
Input: 0 to 6
0 = Machine without electronic handwheel
1 = Portable handwheel HR 330
2 = Panel-mounted handwheel HR 130
3 = Portable handwheel HR 330 (evaluation of keys via PLC)
4 = Portable handwheel HR 332 (evaluation of keys via PLC)
5 = Up to three HR 150 via HRA 110
6 = Reserved
MP7641 Entry of interpolation factor
Input: 0 to 15
Bit 0
+0 = Entry of interpolation factor via TNC keyboard
+1 = Entry of interpolation factor via PLC module 9036
Bit 1 +0 =
+2 = Handwheel active in the Programming and editing mode
Bit 2 +0 =
+4 = Entry of interpolation factor via PLC module and TNC keyboard
Bit 3 +0 =
+8 = Key polling (except axis keys) from the PLC in every operating mode
MP7650 Count direction for handwheel
Input: 0 or 1
0 = positive count direction
1 = negative count direction
MP7660 Threshold sensitivity for electronic handwheel
Input range: 0 to 65 535 [increments]
MP7670 Minimum interpolation factor for handwheel
Input range: 0 to 10
Marker Function Set Reset
M2826 Suppress handwheel pulses PLC PLC