HEIDENHAIN TNC 335 Technical Manual - Manual (Page 356)

5-12
TNC 360 3 List of Machine Parameters 4/96
Machine
parameter Function and input Reaction /
CN 123 Page
MP3130 Polarity of the S-analog voltage
Input value: 0 to 3
0 = M03 positive voltage
M04 negative voltage
1 = M03 negative voltage
M04 positive voltage
2 = M03 and M04 positive voltage
3 = M03 and M04 negative voltage
4-80
MP3140 Count direction of the measuring system signals
for the spindle
Input value: 0 or 1
0 = Positive count direction with M03
1 = Negative count direction with M03 4-81
MP3210.0
to
MP3210.7 S-analog voltage for gear range
Input value: 0 to 9.999 [V] 4-82
MP3240.0 Maximum S-analog voltage output
Input: 0 to 9.000 [V] 4-82
MP3240.1 Minimum S-analog voltage output
Input value: 0 to 9.999 [V] 4-82
MP3240.2 Jog voltage for gear change
Input value: 0 to 9.999 [V] 4-86
MP3310.0 Limit with S override (maximum)
Input value: 0 to 150 [%] 4-84
MP3310.1 Limit with S override (minimum)
Input value: 0 to 150 [%] 4-84
MP3410.0 Ramp slope for spindle for M03, M04, M05
Input range: 0 to 1.999 [V/ms] 4-82
MP3410.1 Ramp slope of the analog voltage for
Spindle orientation
Input value: 0 to 1.999 [V/ms] 4-93
MP3410.2 Ramp slope for tapping
Input value: 0 to 1.999 [V/ms] 4-100
MP3410.3 Accelerations ramp for rigid tapping
Input value: 0 to 1.999 [V/ms] 4-104
MP3420 Positioning window for spindle
Input range: 0 to 65 535 [increments]
1 increment is equivalent to about 0.088°
4-95
MP3430 Reference mark deviation from the desired
position (Spindle preset)
Input value: 0 to 360 [°] 4-95
MP3440.0
to
MP3440.7 k
v
factor for spindle orientation
Input range: 0.1 to 10 [m/min/mm]
4-95