HEIDENHAIN TNC 335 Technical Manual - Manual (Page 354)

5-10
TNC 360 3 List of Machine Parameters 4/96
Machine
parameter Function and input Reaction /
CN 123 Page
MP1390 Control with lag or feed forward control
Input range: 0 or 1
1 = operation with lag
0 = operation with feed forward control
4-52
3.3 Operation with feed forward control
Machine
parameter Function and input Reaction /
CN 123 Page
MP1410 Position monitoring in operation with feed forward
(cancelable)
Input value: 0.001 to 30 [mm] 4-70
MP1420 Position monitoring in operation with feed forward
(EMERGENCY STOP)
Input value: 0.001 to 30 [mm] 4-70
MP1510.0
to
MP1510.3 k
v
factor for feed forward control
Input value: 0.1 to 10 [m/min/mm]
4-62
MP1520 Position approach speed
Input value: 0.1 to 10 [m/min] 4-62
MP1530 Damping factor for transient response
Input value: 0.01 to 0.999 4-62
3.4 Operation with servo lag
Machine
parameter Function and input Reaction /
CN 123 Page
MP1710 Position monitoring for operation with lag
(cancelable)
Input value: 0.001 to 1000 [mm] 4-69
MP1720 Position monitoring for operation with lag
(EMERGENCY STOP)
Input value: 0.001 to 1000 [mm] 4-69
MP1810.0
to
MP1810.3 k
v
factor for operation with lag
Input range: 0.1 to10 [m/min/mm]
4-56
MP1820 Multiplication factor for the k
v
factor
Input value: 0.001 to 1
4-58
MP1830 Kink point
Input value: 0 to 100 [%] 4-58