HEIDENHAIN TNC 335 Technical Manual - Manual (Page 301)

4-204
TNC 360 15 Tool Changer 8/95
M
→
N: Normal tool follows Manual tool
With this toolchange sequence two pocket numbers (or tool numbers) must be transferred in
succession. M2093 indicates that another TOOL CALL strobe (M2046) follows.
Irrespective of marker M2600, pocket number 255 and tool number 0 are transferred first. Tool
number 0 tells the PLC to clear the spindle. Pocket number 255 means that there is no pocket in the
tool magazine for the called tool. After acknowledging with M2483, the pocket number and tool
number of the new tool (called tool) are transferred.


0


0


0 


0


0


0


0


0
3RFNHW1R3RFNHW1R>1@ :
7RRO1R7RRO1R>1@
: