HEIDENHAIN TNC 335 Technical Manual - Manual (Page 487)

7-108
TNC 360 4 PLC Modules 8/95
4.7 Module 9036: Transfer PLC status information to the NC
Module 9036 transfers all or individual axes from the PLC to the NC (for display of interpolation
factors and handwheel functions).
Module call:
PS B/W/D/K Type of PLC status information
PS B/W/D/K PLC status value
CM 9036
PL B/W/D
Status messages that are filed in the STACK:
0: PLC status information was transferred
1: Incorrect type of PLC status information
2: Transferred PLC status information incorrect
3: Write inhibited (e.g. through MP)
When the PLC status information has been transferred, Marker M3171 is reset.
Type of NC status information: PLC status value:
0: Handwheel interpolation factor 0 ... 10
X axis
1: Handwheel interpolation factor 0 ... 10
Y axis
2: Handwheel interpolation factor 0 ... 10
Z axis
3: Handwheel interpolation factor 0 ... 10
IV axis
4: Handwheel interpolation factor 0 ... 10
all axes
5: Handwheel interpolation factor 0 ... 10
all axes
6 to 9 reserved
10: jog distance limitation 0 to 50 mm
<0 or >50 = limit canceled