ProSoft Technology PTQ-101M - Manual (Page 100)

PTQ-101M ♦ Quantum Platform Diagnostics and Troubleshooting
IEC 60870-5-101 Master Communication Module
Page 100 of 181 ProSoft Technology, Inc.
May 14, 2008
6.4.3 IEC-101M Master Menu
Press [I] from the Main Menu to open the ICE-870-5-101 Master Driver Menu.
Use this menu command to view detailed configuration information for the
module.
? = Display Menu
A = Data Analyzer
C = General Configuration
I = Command List Menu
P = Port Configuration Menu
Q = Port Status Menu
S = Session Menu
V = Version
Z = Previous Menu
I = IEC-101 Master Driver Menu
Displays version information
Displays Data Analyzer screen
Goes up one level to main menu
Redisplays (refreshes) this menu
Opens Session Configuration Menu
Displays General Configuration screen
Opens Port Configuration Menu
Opens IEC-870-5-103 Master Command List menu
Opens Port Status Menu
M = Main Menu
See IEC-101 Master
Command List section
See Port Configuration
section
See Port Status section
See Session Configuration
section
Redisplaying the Menu
Press [?] to display the current menu. Use this command when you are looking
at a screen of data, and want to view the menu choices available to you.
Opening the Data Analyzer Menu
Press [A] to open the Data Analyzer Menu. Use this command to view all bytes
of data transferred on each port. Both the transmitted and received data bytes
are displayed. Refer to Data Analyzer for more information about this menu.
Important: When in analyzer mode, program execution will slow down. Only use this tool during a
troubleshooting session. Before disconnecting from the Config/Debug port, please press [S] to stop
the data analyzer, and then press [M] to return to the main menu. This action will allow the module
to resume its normal high speed operating mode.
Viewing Protocol Configuration
Press [C] to view configuration information for the 101M protocol.
Opening the Command List Menu
Press [I] to open the Command List menu. Use this command to view the
configured command list for the module.
Viewing Port Configuration
Press [P] to view configuration information for the application port.
Use this command to display detailed configuration information for the port.