ProSoft Technology PTQ-101M - Manual (Page 63)

Configuring the Processor with UnityPro XL PTQ-101M ♦ Quantum Platform
IEC 60870-5-101 Master Communication Module
ProSoft Technology, Inc. Page 63 of 181
May 14, 2008
4.5 Connect Your PC to the Processor
The next step is to connect to the processor so that you can download the project
file. The processor uses this project file to communicate over the backplane to
modules identified in the project file.
Note: If you have never connected from the PC to your processor before, you must verify that the
necessary port drivers are installed and available to UnityPro XL.
To verify address and driver settings in UnityPro XL:
1 Open the PLC menu, and choose Standard Mode. This action turns off the
PLC Simulator, and allows you to communicate directly with the Quantum or
Unity hardware.
2 Open the PLC menu, and choose Set address... This action opens the Set
address dialog box. Open the Media dropdown list and choose the
connection type to use (TCPIP or USB).