ProSoft Technology PTQ-101M - Manual (Page 13)

Configuring the Processor with Concept PTQ-101M ♦ Quantum Platform
IEC 60870-5-101 Master Communication Module
ProSoft Technology, Inc. Page 13 of 181
May 14, 2008
2 Configuring the Processor with Concept
In This Chapter
Information for Concept Version 2.6 Users............................................ 14
Create a New Project ............................................................................ 15
Add the PTQ Module to the Project....................................................... 18
Set up Data Memory in Project.............................................................. 20
How to Set up and Use the Sample Function Block for Concept........... 23
Download the Project to the Processor ................................................. 36
Verify Successful Download .................................................................. 39
The following steps are designed to ensure that the processor is able to transfer
data successfully with the PTQ module. As part of this procedure, you will use
Concept configuration software from Schneider Electric to create a project, add
the PTQ module to the project, set up data memory for the project, and then
download the project to the processor.
Important Note: Concept software does not report whether the PTQ module is present in the rack,
and therefore is not able to report the health status of the module when the module is online with
the Quantum processor. Please take this into account when monitoring the status of the PTQ
module.