ProSoft Technology PTQ-101M - Manual (Page 156)

PTQ-101M ♦ Quantum Platform Reference
IEC 60870-5-101 Master Communication Module
Page 156 of 181 ProSoft Technology, Inc.
May 14, 2008
Error Description
602 Session not reserved
603 Illegal session
604 Session is reserved
605 Session is not available
701 No memory to transmit message
702 ASDU not supported
703 Duplicate request
704 Illegal sector
705 Control mode is illegal
801 Partial stop request
802 Stop request failed
901 Response timeout
902 Negative COT in response
903 Session is offline
904 Session is disabled
905 Select confirmation received, waiting to execute
906 Execute confirmation has not be received
7.6 Configuration Data Definition
This section contains a listing of the parameters and their definitions for the PTQ-
101M module configuration file definition (IEC101M.CFG).
[Section]/Item Value Range Description
[Backplane Configuration] Backplane transfer parameters
Module Name: 0 to 80
characters This parameter assigns a name to the module that
can be viewed using the configuration/debug port.
Use this parameter to identify the module and the
configuration file.
4x Register Start: 1 to n This parameter sets the first register in the
processor where the data transferred from the
processor to the module is present.
Write Register Start: 0 to 3999 This parameter specifies the starting register in
the module where the data transferred from the
processor will be placed. Valid range for this
parameter is 0 to 3999.
Write Register Count: 0 to 4000 This parameter specifies the number of registers
to transfer from the processor to the module. Valid
entry for this parameter is 0 to 4000.
3x Register Start: 1 to n This parameter sets the first register in the
processor where the data transferred from the
module to the processor will be placed.
Read Register Start: 0 to 3999 This parameter specifies the starting register in
the module where data will be transferred from the
module to the processor. Valid range for this
parameter is 0 to 3999.