Panasonic AV-UHS500 12G-SDI/HDMI UHD 4K Compact Live Switcher - Manual (Page 133)

133
Remote camera link functions
Remote camera settings
When the unit is connected to the remote camera, you can make settings on the camera from this unit.
Selecting the remote camera, checking information, and controlling power
1 Press the CAM
CONT
button to light its indicator and display the Camera menu.
2 Use [F1] to display the Camera Information sub menu.
3 Use [F2] to select the input source of the remote camera you want to set in Input Selection.
You can check the following information.
Name The name of the remote camera connected to the unit is displayed. The name set on the remote camera is displayed.
Model The model names of the remote cameras connected to the unit are displayed.
Status The IP connection status of the unit and the remote cameras is displayed.
No IP Address
The IP address of the camera has not been entered in the Input menu
Now Checking… The unit and the remote camera are communicating and are not yet finished
Connected The unit and the remote camera are communicating normally
Unauthorized Authentication information for the unit and the remote camera has not been entered or is
incorrect
Not Connected There is a communication error between the unit and the remote camera
Please Wait… Remote camera currently switching between power ON and standby
Pan & Tilt Alarm A problem has been detected with the pan/tilt of the remote camera
Fan Alarm A problem has been detected with the fan of the remote camera
Other Alarm A problem has been detected with something other than the pan/tilt or fan of the remote
camera
4 Use [F1] to display the Camera Control sub menu.
5 Use [F2] and switch between power ON and standby for the remote camera corresponding to the input signal selected in
the Power item.
6 Use [F3] to turn ON all of the remote cameras connected to this unit in the All Power On item.
7 Use [F4] to set to standby all of the remote cameras connected to this unit in the All Standby item.
8 Use [F5] to switch the use for [Z] in the Z-Dial Usage item.
P-T Sp. & Zoom Either adjust the control speed for pan/tilt or set the zoom control.
Press and you can switch the control speed and zoom control.
P-T Speed Only Set only the pan/tilt control speed adjustments.