Panasonic AV-UHS500 12G-SDI/HDMI UHD 4K Compact Live Switcher - Manual (Page 33)

33
Basic operations
Single SHIFT
Single SHIFT is used to switch the individual material of a
PGM/A bus crosspoint button, PST/B bus crosspoint button
or AUX bus crosspoint button from a front material to a rear
material or vice versa.
Switching between the front material and rear material is
done using the crosspoint button in which the SHIFT function
is allocated.
The SHIFT function can be allocated to button No.12 or No.1.
w Allocating the SHIFT function
1 Press the XPT
MV
button to light its indicator, and display
the XPT menu.
2 Use [F1] to display the XPT Setting sub menu.
3 Use [F2] to select the button to which the SHIFT
function is to be allocated using the Shift item.
Right Button No.12
Left Button No.1
Off Function is not allocated.
4 Use [F3] to select the operation to be performed when
the [SHIFT] button is pressed using the Shift-Lock item.
Off The rear material is selected only while the
[SHIFT] button is pressed.
On The front material and rear material are
switched each time the [SHIFT] button is
pressed.
p To use the materials that have been set in the button
to which the SHIFT function is allocated, either set the
SHIFT function Off or allocate the SHIFT function to
another button.
p If the [SHIFT] button for “Single SHIFT” is pressed when
the rear materials (13 to 24) have been selected using
“All SHIFT”, the bus crosspoint buttons concerned will be
switched to the front materials.
p When the crosspoint buttons are held down, the button
numbers and the names of the input materials assigned
to the buttons are displayed on the built-in display in the
form of a list for as long as the crosspoint buttons remain
held down.
Selecting the bus mode
Select the A/B bus system or flip-flop system (PGM/PST
system) from the setting menu.
1 Press the CONF
SYS
button to light its indicator, and display
the Config menu.
2 Use [F1] to display the Operate sub menu.
3 Use [F2], and select the A/B or PGM/PST (flip-flop
system) using the Bus Mode item.
A/B When the fader lever is at side A, the signals
selected by the A bus are replaced PGM bus
materials.
When the fader lever is at side B, the signals
selected by the B bus are replaced PGM bus
materials.
PGM-A/
PST-B Using a flip-flop system, the signals selected
by the A bus are always replaced PGM bus
materials, and the signals selected by the
B bus are always replaced PST bus
materials.
PGM-B/
PST-A Using a flip-flop system, the signals selected
by the B bus are always replaced PGM bus
materials, and the signals selected by the
A bus are always replaced PST bus
materials.
Selecting the transition mode
Select the transition mode using the [MIX] and [WIPE]
buttons.
1 Press the [BKGD] button in the transition area so that its
indicator lights in amber.
When the [BKGD] button and [KEY] button are pressed
at the same time, both buttons are selected.
2 Use the [MIX] and [WIPE] buttons in the transition area
to select the background transition mode.
The indicator of the selected button lights in amber.