Teledyne LeCroy Merlins Wand - Users Manual - Manual (Page 24)

8
CATC M ERLIN ’ S W AND 2.00 C HAPTER 2
User’s Manual Getting Started
letter of the CD-ROM drive for <drive>. For example, if the
CD-ROM drive is drive D, navigate to
D:\software\MerlinWand122.
Note : If you are using installation files downloaded from the CATC website, you will
need to direct the wizard to the Disk 1 directory of the installation files so that it
can locate the driver.
2.3 Installing the Software and Starting the Program
The Merlin’s Wand software can be installed from the installation CD-ROM
or from installation files downloaded from the CATC website.
Install from CD-ROM
Step 1
Insert the Merlin’s Wand installation CD-ROM into the
CD-ROM drive of the computer that will be connected to the
Merlin’s Wand hardware.
The autorun program should start automatically. If it doesn’t start, use
Windows Explorer or My Computer to navigate to the CD-ROM drive
directory and double-click the file autorun.exe, and proceed to Step 2. If
it still doesn’t start, navigate to the \software\MerlinWand122 directory
on the CD-ROM, double-click the file Setup.exe, and proceed to Step 3.
Step 2
Choose Install Software to start the setup program.
Step 3 Follow the on-screen instructions to complete the
installation.
Install from installation download
Step 1
Select Start > Run... from the Windows taskbar and click
the Browse button, then navigate to the Disk 1 directory of
the Merlin’s Wand installation download. Select the file
Setup.exe and click Open.
Step 2
Follow the on-screen instructions to complete the
installation.
Start the program
Once the software has been installed, be sure that the Merlin’s Wand
hardware is connected to the PC via the USB cable before starting the
Merlin’s Wand application. Otherwise, the application will provide a
warning message telling you that the Wand could not be found.