Teledyne LeCroy Merlins Wand - Users Manual - Manual (Page 61)

45
CATC M ERLIN ’ S W AND 2.00 C HAPTER 4
User’s Manual Command Generator
The Command Generator utility will open.
Step 2
Choose a protocol to
work with by clicking
one of the five tabs or a
layer in the Protocol
Stack Graphic.
The list of available
commands for the
chosen protocol
will display in the
Command Menu.
Note : The HCI tab is displayed by default.
Step 3 Select a command from the Command Menu.
A description of the command will display in the Command Description
Box. If the selected command is not supported, the message in the
Command Description Box will read “Not supported.”
Step 4 Enter parameters, if required, in the Parameters Combo Boxes.
Parameter boxes will be activated as appropriate for the command,
with the parameter name(s) appearing to the right of the box(es).
Data can be typed directly into the Parameters Combo Boxes, and
some of the boxes may offer drop-down lists from which to select
the appropriate parameter.
Note : Numeric values should be entered as hexadecimal unless otherwise specified.
Step 5
Click the Execute button to run the command.
Note : While Command Generator offers maximum control over Merlin's Wand, there
are times when command choices may be limited. Some lower-level connections
may prevent access to commands for higher-level protocols. For example, if an
L2CAP connection has been established between Merlin's Wand and a device, it
is not possible to work with OBEX commands in Command Generator. Merlin's
Wand will display a message to indicate that L2CAP connections must be closed
before working with OBEX commands. Once the L2CAP connection is closed,
the OBEX commands will be accessible.
Customizing the List of HCI Commands
The list of commands in the HCI command menu in Command Generator
may be customized to display only certain commands. Since there are over
100 commands available in the HCI menu, this feature is a handy way to
eliminate scrolling through a lengthy list to find commands.