Teledyne LeCroy Merlins Wand - Users Manual - Manual (Page 53)

37
CATC M ERLIN ’ S W AND 2.00 C HAPTER 3
User’s Manual Profile Wizard
Step 3
Click Next.
Step 4 Select the appropriate security options, and click Next.
•
Send Control Packet: Use this to select a filter control message to
send to the remote device. You may send either a Filter Network
Protocol Type message or a Filter Multicast Address Type message
control packet to the remote device.
Start Range and End Range: Start Range defines the beginning of
the range, and End Range defines the end of the range. Only the
protocol types or multicast addresses that fall within the range will be
sent by the remote device; all other types or addresses will be filtered
out.
For Filter Network Type Set Message, the Start and End Ranges may
be in the format nnnn or 0xnnnn. For the Filter Multicast Address Set
Message, the Start and End Ranges can be in the format
nnnnnnnnnnnn or 0xnnnnnnnnnnnn.
•
Send Packet: Use this to send an ethernet packet to the remote
device. The types of ethernet packets that can be sent are General,
Compressed, Compressed Source Only and Compressed Destination
Only.
Note Depending on your network settings for ‘CATC Bluetooth Trainer PAN Virtual
NIC’ Local Connection, Windows may create additional network traffic over this
connection. Check your network properties for ‘CATC Bluetooth Trainer PAN virtual
NIC.’
Emulate Device: PAN - NAP
Note To connect to a device that uses the PAN profile, you must install the virtual
network driver that is included with the Merlin’s Wand installation. For instructions, see
Section 3.7, “Installation of Network Driver,” on page 41.
Step 1
Complete Steps 1-4 in Section 3.3, “Emulating Devices” on
page 30.
Step 2 In the Select Profile screen, select PAN-NAP, and click
Next.
The Emulation Status screen will open, indicating that Merlin’s Wand
has been configured to emulate a Bluetooth device that supports the
PAN-NAP profile and is awaiting connection from a device. It is now
ready to receive files.