Teledyne LeCroy Merlins Wand - Users Manual - Manual (Page 41)

25
CATC M ERLIN ’ S W AND 2.00 C HAPTER 3
User’s Manual Profile Wizard
Connect to Device: Headset Audio Gateway
The following steps show how to configure Merlin’s Wand to connect to
and transfer audio with a Bluetooth headset that uses the Headset Audio
Gateway profile.
Note In order to verify that Merlin’s Wand and a Bluetooth audio device are successfully
connected, a headset will need to be plugged into the audio port on Merlin’s
Wand. Be sure that the headset is plugged in before starting configuration and
initializing the connection between Merlin’s Wand and the headset.
Step 1
Complete steps 1-6 in Section 3.2, “Connecting to Devices”
on page 17.
Step 2 Select Headset Audio Gateway from the list on the Select
Profile screen.
(Optional) Select the Allow Role Switch option on the screen to enable
Merlin’s Wand to switch roles during the connection.
Step 3
Click Next.
The Wizard will advance to the Connection Status screen, and Merlin’s
Wand will attempt to establish a connection to the device.
If the connection attempt is successful, the Connection Status screen will
show that Merlin’s Wand has established a connection with the device.
Note If you cannot establish a connection, you can re-attempt the connection by either
pressing Back and re-running the previous two steps, or by pressing the Connect
button again.
Note The Speaker and Microphone Volume levels can be adjusted by moving the sliders
up or down. The level is indicated by a number, from 0 to 15, to the left of each
slider.
Step 4
To verify that Merlin’s Wand and the Bluetooth device are
successfully connected, speak into the microphone on one
device and listen for audio on the other.
At this point, the audio signal should transfer to the headset. Listen to the
headset to see if the data transfer is successful.
Step 5
(Optional) Click the Disconnect button on the Connection
Status screen to close the connection.
The connection between Merlin’s Wand and the device will terminate,
and the Connect button will again be available. Selecting Connect will
reestablish the connection.