Connect to device: headset, Click next – Teledyne LeCroy Merlins Wand - Users Manual User Manual
Page 40
24
CATC M
ERLIN
’
S
W
AND
2.00
C
HAPTER
3
User’s Manual
Profile Wizard
Connect to Device: Headset
The following steps show how to configure Merlin’s Wand to connect to
and transfer audio with a Bluetooth headset that uses the Headset profile.
Note
In order to verify that Merlin’s Wand and a Bluetooth audio device are successfully
connected, a headset will need to be plugged into the audio port on Merlin’s
Wand. Be sure that the headset is plugged in before starting configuration and
initializing the connection between Merlin’s Wand and the headset.
Step 1
Complete steps 1-6 in Section 3.2, “Connecting to Devices”
on page 17.
Step 2
Select Headset from the list on the Select Profile screen.
(Optional) Select the Allow Role Switch option on the screen to enable
Merlin’s Wand to switch roles during the connection.
Step 3
Click Next.
The Wizard will advance to the Connection Status screen, and Merlin’s
Wand will attempt to establish an RFCOMM connection to the device.
If the connection attempt is successful, the Connection Status screen will
show that Merlin’s Wand has established an RFCOMM connection with
the device. Merlin’s Wand will automatically ring the target device and
wait for an answer. Pressing the Ring button will cause Merlin’s Wand
to ring the device again.
When the target device answers, Merlin’s Wand will establish an SCO
connection with it.
Note
If you cannot establish a connection, you can re-attempt the connection by either
pressing Back and re-running the previous two steps, or by pressing the Connect
button again.
Note
The Speaker and Microphone Volume levels can be adjusted by moving the sliders
up or down. The level is indicated by a number, from 0 to 15, to the left of each
slider.
Step 4
(Optional) Click the Disconnect button on the Connection
Status screen to close the connection.
The connection between Merlin’s Wand and the device will terminate,
and the Connect button will again be available. Selecting Connect will
reestablish the connection.