Teledyne LeCroy Merlins Wand - Users Manual - Manual (Page 34)

18
CATC M ERLIN ’ S W AND 2.00 C HAPTER 3
User’s Manual Profile Wizard
Note To connect to a device that uses the Dial-Up Gateway, Fax Gateway, LAN, or Serial
Port profile, you will need to install the virtual COM port driver that is included
with the Merlin’s Wand installation. For instructions, see “Installing the Virtual
COM Port Driver” on page 39.
Step 1 Turn on the target device.
Step 2
Open Profile Wizard and click the Connect to Device
button.
Merlin’s Wand will perform a General Inquiry to collect information on
local devices, then list the devices that are found on the Select Device
screen.
(Optional) Uncheck “Skip Name Search” so that Merlin’s Wand will not
try to discover the devices’ user-friendly names. This will speed up the
search.
Note If no devices are found, you can click Search to have Merlin’s Wand repeat the
General Inquiry.
Step 3
Select device from list
From the list, select the device address to which you want
Merlin’s Wand to connect.
Add address
Click the Add Address button in order to use an address that does not
appear in the list.
The Add Address dialog appears.
Enter the device address in 12-digit hexadecimal format. To enter a pin
code to use with the device, check the option “For connections with this
device, use the following PIN code” and then enter the code.
Click OK to close the dialog.
Add PIN code
To use a PIN code with a device that you selected from the list, click the
Enter PIN button to open the Enter PIN dialog.
Enter the PIN for the device, then click OK to close the dialog.
Step 4
Click Next.
You will advance to the Configure Security screen.
Step 5
Select the security option that you want to apply for the
device.
•
Do not apply authentication and encryption.
Authentication and encryption will not be used.