Teledyne LeCroy Merlins Wand - Users Manual - Manual (Page 45)

29
CATC M ERLIN ’ S W AND 2.00 C HAPTER 3
User’s Manual Profile Wizard
Step 4
You can now perform the following operations:
•
Send Control Packet: Use this to select a filter control message to
send to the remote device. You may send either a Filter Network
Protocol Type message or a Filter Multicast Address Type message
control packet to the remote device. The only types of network
filtering allowed are ARP (0806) and IPv4 (0800).
Start Range and End Range: Start Range defines the beginning of
the range, and End Range defines the end of the range. Only the
protocol types or multicast addresses that fall within the range will be
sent by the remote device; all other types or addresses will be filtered
out.
For Filter Network Type Set Message, the Start and End Ranges may
be in the format nnnn or 0xnnnn. For the Filter Multicast Address Set
Message, the Start and End Ranges can be in the format
nnnnnnnnnnnn or 0xnnnnnnnnnnnn.
•
Send Packet: Use this to send an ethernet packet to the remote
device. The types of ethernet packets that can be sent are General,
Compressed, Compressed Source Only and Compressed Destination
Only.
Note Depending on your network settings for ‘CATC Bluetooth Trainer PAN Virtual
NIC’ Local Connection, Windows may create additional network traffic over this
connection. Check your network properties for ‘CATC Bluetooth Trainer PAN virtual
NIC.’
Connect to Device: Serial Port
These steps describe how to use Profile Wizard to configure Merlin’s Wand
to connect to a device that uses the Serial Port profile for serial port
emulation.
Note To connect to a device that uses the Serial Port profile, you will need to install the
virtual COM port driver that is included with the Merlin’s Wand installation. For
instructions, see “Installing the Virtual COM Port Driver” on page 39.
Step 1 Complete steps 1-6 in Section 3.2, “Connecting to Devices”
on page 17.
Step 2
Select Serial Port from the list on the Select Profile screen.
(Optional) Select the Allow Role Switch option on the screen to enable
Merlin’s Wand to switch roles during the connection.
Step 3 Click Next.
The Wizard will advance to the Connection Status screen, and Merlin’s
Wand will attempt to establish a connection to the device.